Heating System Installation in Chișinău and Across Moldova

We install gas, electric, solid fuel, and combined boilers with proper heat loss calculations and correct piping configuration. Incorrect capacity selection leads to excessive fuel consumption and heat exchanger overheating. We calculate parameters before installation, perform connection, automation setup, and initial startup with pressure and safety checks.

We design hydronic underfloor heating systems with calculated pipe spacing and temperature режим. With proper setup, supply temperature can be 10–15% lower than in radiator systems, reducing heating costs. Incorrect installation leads to uneven heating and floor screed cracking — we eliminate these risks.

We install heat pumps based on heat loss calculations and capacity selection adapted to Moldova’s climate. With a COP of 3–4, the system generates 3–4 times more heat than the electricity it consumes. Design errors cause constant overload and efficiency loss — we prevent this.

We connect storage and instantaneous water heaters considering water pressure and electrical load. Incorrect installation causes temperature fluctuations and accelerated heating element wear. Proper connection ensures stable hot water supply and safe equipment operation.

We install radiators based on thermal output calculations for each room and proper connection схемe. System balancing prevents cold spots and boiler overheating. Without precise calculation, some rooms remain underheated while fuel consumption increases.

We install water and electric towel warmers considering system pressure and coolant circulation. Incorrect connection can cause airlocks and reduce heating efficiency. We ensure stable heating without affecting the overall system performance.

We design chimneys with proper diameter and draft calculation according to boiler capacity. Errors at this stage reduce efficiency and may lead to emergency shutdown. We check tightness, draft, and compliance with standards before commissioning.

We install internal and external sewer systems with proper slope and pipe diameter calculation. Incorrect slope leads to blockages and backflow. Proper installation ensures stable wastewater drainage and protects engineering systems from overload.