Polyethylene clamping tee PN 6 bar, d. 75 x 2.1/2" x 75 (male)

The PN 6 bar 75 × 2½″ × 75 (male) HDPE compression (clamp) tee is designed to branch a 75 mm HDPE pipeline while providing a 2½″ male threaded outlet on the side. The straight run connects two 75 mm pipe sections to maintain flow capacity, and the 90° branch offers a convenient connection point for valves, filters, distribution nodes, threaded adapters, irrigation zones, or a separate supply line. It is an excellent solution for fast installation without welding.

Typical uses

outdoor cold water supply networks (private and commercial sites);

irrigation/watering systems (zone feeds, manifolds, splitters);

technical pipelines and on-site distribution assemblies;

upgrades of existing lines where welding is impractical.

Material and durability

Made from HDPE, the fitting:

resists corrosion and will not rust;

withstands common water impurities and typical technical media;

keeps its shape and strength over long service life.

The PN 6 bar rating suits standard operating conditions requiring stable, leak-tight joints.

Key benefits

No welding required: no electrofusion equipment or special tools.

Leak-tight compression joint: secure grip on 75 mm pipe.

2½″ male thread: quick connection to standard female-thread components.

Demountable: convenient for repairs, relocations, and seasonal reconfiguration.

Installer-friendly: suitable for trenches, manholes, and confined areas.

Installation (quick overview)

Prepare the 75 mm pipe (square cut, remove burrs).

Insert the pipe fully to the stop.

Tighten the nuts to compress and seal.

Connect equipment to the 2½″ male thread using an appropriate sealant.

SEO keywords: HDPE compression tee 75 2½ inch male, 75×2½″×75 clamp tee, HDPE tee with 2½″ male thread, PN 6 bar, 75 mm HDPE branch tee.